Picture
Siska can make your Machine Great Again!
800-393-5381
REBUILT MACHINERY
In the Refurbishing/Rebuilding of machinery, we first select a good used unit to start with. The following procedures then take place:
  • The machine is stripped down to the bare frame.
  • The frame and all it's components are chemically cleaned & sand blasted
  • The frame & all components are then checked for wear & cracks
  • At this point, any parts not adhering to new specifications are replaced
  • Everything is then painted with high quality enamel paint
  • All shafts & non castings are de-burred & micro polished
  • The machine is now reassembled adhering to manufacturer's specifications
  • The eyelet/grommet feed unit is then sized to the customer's needs
  • New tooling/dies are installed
  • New Motor, switch & wiring are installed
  • When the machine rebuild process is complete, it is then adjusted, lubricated & tested with samples provided by customer.